- Building Systems
- Mobile Systems
- HotSpot · Router · Modem
- Phone Accessories
* Discontinued - No Longer Available
• For Mid-Sized Buildings - Homes, Small Offices, etc.
• Improves Voice and Data Signals to Multiple Devices Simultaneously
• Boosts Voice & 3G Data for Most Carriers (AT&T, Verizon, Sprint, T-Mobile, etc. (except Clearwire/WiMax and Nextel/iDen)
• Works Great With Cell Phones & Other Data Devices like Wireless Modems, USB Wireless Adapters, MiFi Devices & Mobile HotSpots
• Complete kit - DIY installation; Includes: 3G Amplifier, Outside Directional Antenna, Inside Panel Antenna and two 30' cables (RG-6 Quad Shield)
• Directional antenna provides stronger incoming signal resulting in improved indoor coverage area. Antenna must be aimed at tower or signal coming off of tower
• FCC Certified to 2014 Techinical Specifications
Part #462205 (formerly 841263)
The Wilson Electronics DB Pro™ cellular signal booster improves cellular coverage for most North American cellular networks. It does not require any physical connection to your phone and improves reception to multiple devices simultaneously including cell phones, hotspots and cellular data cards. The DB Pro kits feature easy setup and installation and each kit features the adjustable-gain DB Pro dual-band signal booster. The adjustable gain controls allow the installer to optimize the unit’s gain to match the requirements of the building in which it’s installed. This kit includes Wilson's Wide Band outdoor directional antenna. The inside panel antenna, which rebroadcasts the amplified cell signal inside the building, is designed for optional flush mounting in the ceiling or wall. Components are connected using standard TV (RG-6) coax cable, which is often pre-wired in buildings. With the DB Pro, you’ll see fewer dropped calls, faster downloads and a stronger, more reliable cellular signal indoors.
Optional Wilson Lightning Surge Protector AM859992 recommended.
The gain on the SignalBoost DB Pro is adjustable in 5db increments up to 62db for 800MHz and 65db for 1900MHz. Being able to adjust the amplifier gain makes installation easier in situations where there might be a challenge getting enough separation between the inside and outside antenna.
Using the directional antenna included in this kit will improve the coverage area inside. This directional antenna focuses a higher gain towards your provider's tower.
Important Note: The down side of using a directional antenna is that it focuses towards one direction. If you are trying to improve the signal for multiple service providers and their towers are in opposite directions, the coverage of one service provider may be weaker. If this is the case, we would recommend the DB Pro 3g Omni Directional Antenna Kit 462105 (or upgrading just the outside antenna to the 75 ohm omni-directional building mount antenna 311201 with F female).
Wilson Panel Antenna
The Wilson Panel antenna is typically used as an indoor antenna and is wall mounted but can be ceiling mounted on higher ceilings (10ft or higher). They work well across longer, more narrow areas. Since they typically reach further, they are the prefered inside antenna. The Panel antenna radiates 70 degrees for a more focused beam to reach longer distances. More Panel Antenna Information
Wilson Wide Band Directional Antenna
Wilson Wide Band Directional Antenna covers 700-2500MHz frequencies. It is directional and performs best when pointed toward your cellular providers tower. If you are trying to boost the signal from one service provider tower, this is the preferred antenna. If you trying to cover multiple service providers and their towers are in different locations, consider the Building Mount Omni Directional Antenna. More Wilson Wide Band Antenna Information
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards.