Wilson Telescoping Antenna Mounting Pole 25 foot [900203]

Wilson Antenna Mounting Telescoping Pole

The Wilson Antenna Telescoping mounting Pole is designed primarily to work with RV applications but can also be used for mounting outdoor antennas on the side of buildings. The pole extends out to 25 feet. (Antenna Not Included)

This pole is compatible with the Outside Omni Antennas (304421, 304422, 304424, 304421), Directional Yagi Antennas (314475, 314411) and Outdoor Panel Antennas (314453, 314473).

Benefits

• Position Antenna Higher For Better Signal
• Increased Isolation Between Donor and Server Antenna
• Provides a More Direct Path to Cell Tower
• Easy Twist Lock Sections

* Antenna Not Included.

Mounting The Pole to Side of an RV

Detailed instructions for setting up this telescoping pole are in the weBoost Destination RV Installation Guide. You can find it on our website at:

https://www.alternativewireless.com/content/installation-docs/weboost/weBoost-Destination-RV-Install-guide.pdf

Here is a brief summary:

Determine where you want to mount telescoping pole on your RV. Extend pole to maximum height. Use wall mount plates and ground mount to secure pole.

We recommend mounting near slider or toy hauler ramp door on the side.

WARNING: Check for and avoid any powerlines or overhead obstructions there may be.

NOTE: DO NOT INSTALL POLE ON RV UNTIL STABILIZER JACKS AND WHEELS CHOCKS ARE IN PLACE AND RV IS IMMOBILIZED.

WARNING: Check for and avoid any powerlines or overhead obstructions there may be.

Clean the flat surface of the RV where wall mounts will be placed. Fully extend the pole and attach the wall mount to the top black ‘foot’ mount located on the pole. Remove the adhesive backer and, making sure the pole is level at a 90° angle, firmly attach the wall mount to the RV near the top. 

There must be at least 4’ of separation between the top and bottom mounts for best performance.

Next, attach the other wall mount to the bottom foot mount located on the pole and insert the attached pin. Then remove the adhesive backer and stick to the clean, flat surface.

RVs With Corrugated Sides
We recommend using the side of a slider. Just ensure the following:

• There is enough clearance for the wall mount to be retracted into the slider.
• There is still 4’ of separation.

Specifications

• Min Length: 6 feet
• Extends To: 25 feet
• Pole Diameter: 2.5 in.
• Base Diameter: 8 in.
• Material: Aluminum Pole with Plastic Wall Mounts, Foot Mount, Ground Mount, Rings, Extension Hold Clamps