| Wilson
AMPS 824-894MHz In Vehicle Cellular Amplifier / Repeater
For Cars, Trucks and RV's
 The
Wilson bi-directional cellular amplifier / repeater greatly improves
signal strength inside a vehicle when using your 800MHz range
cell phone. It does this without physical connection to your phone.
It even allows multiple phones to be used simultaneously.
The
signal is received by the outside antenna from the cell site.
It is then amplified and repeated to your cell phone from the
inside antenna. When the phone transmits, the signal is received
by the inside antenna, amplified, then repeated to the cell site
via the outside antenna.
- Increases
signal strength on send and receive in AMPS 824-894 MHz frequency
range
- Wireless
operation. No physical connection to your phone is required.
- Allows
multiple phones to be use simultaneously.
- Works
on AMPS frequency 824 - 894MHz (Analog and Digital) CDMA, TDMA
and GSM. (Amplifies 824-894 range, 1900MHz is unaffected)
- Your phone
will use less battery power for longer battery life.
Antenna
Requirements (Important)
The
Wilson In Vehicle Amplifier comes with a Wilson Stealth antenna
for inside your vehicle. Another antenna for outside the
vehicle is required and not included.
IMPORTANT: For external antenna use a magnetic mount, pole mount or hole mount antenna. Do not use a glass mount antenna. The Wilson Trucker Antenna, Wilson Dual Band magnetic mount are recommended for outside use. More About Wilson Antennas.
1900MHz
Frequencies
See the Wilson Dual Band Amplifier/Repeaters
for 1900MHz frequencies.
IMPORTANT NOTE: The Wilson Vehicle Amplifier / Repeater is best used in locations where the signal from your service provider is okay outside a vehicle but weak inside the vehicle. It's used where the wireless signal is blocked by the vehicle walls or roof. If your signal is very weak outside of your vehicle where you travel, consider a power booster or antenna that connects directly to your phone (such as Wilson's DirectConnect Power Booster ) for better results.
Specifications
| Frequency |
824-849 MHz Uplink 869-894 MHz Down |
| Gain (up/down) |
40 dB / 40 dB |
| Linear Power Output |
+30 dBm |
| Max Output Power |
3 Watts (Cell Site Controlled) |
| Max RF Up/Down |
+35 dBm / +10 dBm |
| Noise Figure Typical |
4 db nominal |
| Isolation |
Uplink/Downlink more than 90 dB |
| Power Requirements |
12 V, .5-1.5 (subject to Uplink power) |
| Connectors |
FME-Male 50 Ohms |
| Dimensions |
5.5 x 4.3 x 1.4 (inch) or 14.0 x 10.8 x 3.5 (cm) |
| Weight |
1.32 lbs or 0.6 kg |
Please
read the following information before ordering. It will greatly
aid you in the purchase and installation of your Wilson Nextel
Amplifier.
Installation
Instructions
Complete instructions
for installing the Wilson Amplifier / Repeater
Read
brochure
Page
1 | Page
2
NOTE:
The Wilson Amplifier / Repeater is best used in locations where
the signal from your service provider is strong outside a building
or vehicle but weak inside the building. It's used where the wireless
signal is blocked by the building walls or roof. If your signal
is weak outside of your building, consider a power booster or
antenna that connects directly to your phone (such as Wilson's
DirectConnect) for better results.
BUY
NOW!
 Wilson
Vehicle Bi-Directional Amplifier
800MHz AMPS 37db In Vehicle
$259.95
Comes with Vehicle Bi-Directional Amplifier / Repeater, Stealth
Antenna and Cigarette Lighter Power Cord. Requires outside
(non glass mount) antenna with FME Female connector (not included).
IMPORTANT: For external antenna use a magnetic mount, pole mount or hole mount antenna. Do not use a glass mount antenna. Item: AM801101
Don't
forget to order an outside antenna
required with this amplifier but not included.
 Wilson Cell Phone Cradle Plus w/ Built-In Antenna
Use the Wilson Cell Phone Cradle Plus instead of the Inside Antenna that comes with the Wilson Vehicle Bi-Directional Amplifier. Wilson's Cell Phone Cradle Plus adds the benefit of a built-in cell phone signal antenna/coupler.
More Wilson Cell Phone Cradle Plus Info
Wilson 12v Hardwire Power Supply Kit
 $10.95
Enables you connect above Wilson Amplifier/Repeater directly into your car's wiring instead of using the cigarette lighter power cord. NOT for use with newer Wilson "Smart Technology" Building or Vehicle Amplifier / Repeaters.
Wilson 6VDC AC Power Supply
$24.95
 Wilson 6 volt AC (wall outlet) power supply for use with newer "Smart Technology" building and vehicle amplifier / repeaters. Not for use on older 12 volt amplifiers.
AM859912
Wilson 12v Car Cigarette Lighter Power Supply
 $10.95
Power above Wilson Amplifier/Repeater from your car's cigarette lighter outlet. Keep a spare on hand. (This item is included with the above Amplifier/Repeater and Wilson DirectConnect Power Boosters ) NOT for use with newer Wilson "Smart Technology" Building or Vehicle Amplifier / Repeaters.
 Power Booster Black Mesh Carrying Case - Large
Easily transport your power booster, cable and connectors and more. Holds amplifier, cables and power cord (sold separately). Features padded soft sides, vented to facilitate airflow to amplifier, velcro closures, elastic hold down straps for components, zippered pockets for cables and accessories. Holds 2 batteries (sold separately). Size: 10.5 x 9.5 x 2.5 inches / 26.67 x 24.13 x 6.35 centimeters. Larger Picture / Setup Diagram (Flash Required)
Wilson Portable Amplifier Vented Soft Carrying Case - Large
$29.95
Part #AM859924
IMPORTANT NOTE: The Wilson Vehicle Amplifier / Repeater is best used in locations where the signal from your service provider is okay outside a vehicle but weak inside the vehicle. It's used where the wireless signal is blocked by the vehicle walls or roof. If your signal is very weak outside of your vehicle where you travel, consider a power booster or antenna that connects directly to your phone (such as Wilson's DirectConnect Power Booster ) for better results.
|
Help me improve my cell signal 
