Product Description
Protect your expensive cellular signal booster from lightning strikes with this Wilson Electronics 75ohm Lightning Surge Protector. Works with Wilson Electronics 75ohm signal booster systems such as the Wilson Electronics SignalBoost DP Pro and WilsonElectronics AG Pro 70 Signal Booster. Attach between outside antenna and signal booster.
FEATURES & SPECIFICATIONS
- F-Female connectors
- Attenuation less than 0.2 dB
- Frequency range up to 3 GHz
- Replaceable gas discharge element
- Weather Proof
- 75ohm
Where To Install
Install the Lightning Surge Protector (LSP) close to the signal booster. Attach the cable from the outside antenna to the surge protector, using a short length of low loss cable; attach one end to the LSP and the other to the outside antenna connector on the signal booster. Attach a ground wire to the LSP. (For AG Pro 70 or SignalBoost DB Pro 75Ohm systems use Part# 859988 75 Ohm Lightning Surge Protector).
On a grounding bus or point where the equipment to be protected is grounded and as close to the equipment as practicable. NOTE: To insure that the competed installation is weather proof, it is imperative that the mating coaxial connectors be sealed using proper materials and procedures.
You may also be interested in the following product(s)
Wilson 75ohm Lightning Surge Prot w/2ft RG-6 Cable
$74.95
|
Wilson AG Pro 70 Building Cell SignalBooster Bundle KitAs low as: $731.26 |
Additional Information
| SKU | AM859992 |
|---|---|
| Brand | Wilson Electronics |
| Model | 859992 |
| Connector Type | F Female |
| Connector Type 2 | F Female |
| Compatible Devices | No |
| Frequency Range | N/A |
| Accessory Type | Antenna Misc |
| Antenna Category | Misc |
| GTIN | No |
Check items to add to the cart or select all
You have no items to compare.
