The Wilson Electronics In-Line Signal Booster (806215) is designed to offset cable and splitter/tap loss for in-building installations. It should be used on the Inside Antenna side of a Wilson Electronics In-Building Signal Booster such as the AG Pro 75.
An In-Line booster would typically be used by professional installers in larger buildings to provide an additional 17dB gain to compensate for signal loss due to a long cable run or use of taps or splitters to accommodate multiple antennas. The Inline Booster is installed between a Wilson indoor signal booster unit, like the AG Pro Installer and that booster's inside antenna. Optimally the Inline Booster is installed after long runs of cable and/or taps and splitters to compensate for signal loss. The Inline Booster can be installed in the middle of a cable run or near the inside antenna, as needed.
- Boost Signal to Inside Antenna(s) After long cable run
- Boost Signal to Multiple Inside Antennas when using Splitters
- Adjustable Gain - 0 to 17db
- In-Line Amplifier (806215)
- AC/DC Power Supply
- Gain 17db
- Connectors: N Female
- Impedance: 50Ohm
|Connector Type||N Female|
|Frequency Range||800MHz / 1900MHz|