Product Description
Wilson iDen Nextel, Boost Mobile, Southern Linc, Telus MIKE (Canada) In Vehicle Cellular Amplifier / Repeater
For Cars, Trucks and RV's The Wilson bi-directional cellular amplifier greatly improves signal strength inside a vehicle when using your iDen Nextel, MIKE cell phone. It does this without physical connection to your phone. It even allow multiple phones to be used simultaneously.
Comes with:
- Wilson Mobile Bi-Directional Amplifier
- Wilson Cell Phone Cradle
- Outside Wilson Tri-Band Magnetic Mount Antenna (AE304202)
- Cigarette Lighter Power Cord
Nextel Frequency Change - Many Nextel areas are changing frequency from 800MHz to 900MHz. Read More: Nextel Frequency Change
How it Works
The signal is received by the outside antenna from the cell site. It is then amplified and repeated to your cell phone via the inside antenna. When the phone transmits, the signal is received by the inside antenna, amplified, then repeated to the cell site via the outside antenna.
- Increases signal strength on send and receive in iDen 806-866 MHz frequency range
- Wireless operation. No physical connection to your phone is required.
- Allows multiple phones to be use simultaneously.
- Works on Nextel iDen frequency 806-866 MHz
- Your phone will use less battery power for longer battery life.
Nextel iDen Frequency Changes Note: Frequencies in some Nextel areas inside the US are changing to 900MHz. If you are in one of these areas, this amplifier will not work improve your signal.
Home or Office Too!
Add an optional 12 volt AC power supply and use this Wilson Amplifier at your desk in your home or office. Just place the outside antenna outside a window and get at least 6 ft of separation between the 2 antennas. Need to cover more area in side your home or office?
Wilson Mobile Repeater Specifications
- Frequency 806-869 MHz
- Gain 40db
- Max RF Up/Down +35 dBm / +10 dBm
- Noise Figure Typical 4 dB nominal Isolation
- Uplink/Downlink more than 90 dB
- Power Requirements 12 V, .5-1.5 (subject to Uplink power)
- Connectors FME-Male 50 Ohms
- Dimensions 5.5 x 4.3 x 1.4 (inch) or 14 x 10.8 x 3.5 (cm) * Weight 1.32 lbs or 0.7 kg
Additional Information
| SKU | AP804013 |
|---|---|
| Brand | Wilson Electronics |
| Model | 804013 |
| Connector Type | FME Male |
| Frequency Range | iDen 806-866 MHz |
| Gain | 40 db |
| Antenna Category | Amplifier Kits |
| Accessory Type | Signal Improvement |
| GTIN | 813986007075 |
You have no items to compare.
