Wilson Glass Mount Antenna
The Wilson Electronics Cellular Glass Mount Antenna Outperforms the Competition Up to 90% of a cellphone's power on transmit and receive is absorbed within a vehicle and the users head. Wilson solves this problem by channeling all the power from the cell phone to the outside antenna. This results in our glass mount antenna transmitting and receiving over 10 times the signal of a cellular phone used inside a car / truck without an outside antenna.
The Wilson Glass Mount Cellular Antenna was carefully designed to minimize loss and maximize gain on both the 800 MHz and 1900 MHz bands. Wilson accomplished this by using a phasing coil and a low loss coaxial phase reversing device that provides high gain on both frequencies.
Wilson's innovative design results in high efficiency with low losses and will get the most signal to your cellular phone. Thanks to these innovations and our attention to detail Wilson Electronics has the best performing glass mount cellular antenna available.
The Wilson Dual Band Glass Mount Antenna is about 15 tall and includes 14 feet of RG-58 low loss coax cable with FME Female connector.
The Wilson glass mount is mounted using 3M adhesive. The whip with antenna base is mounted outside the vehicle glass and the mount with cable attached is mounted directly opposite on the inside of the vehicle glass.
This cell phone antenna comes with a 90 day warranty. Dual Band: 806-894 MHz /1850-1990 MHz Antenna
- Frequency: 700-800 MHz - Gain: 1.8 dBi
- Frequency: 824-894 MHz - Gain: 3.5 dBi
- Frequency: 880-960 MHz - Gain: 2.8 dBi
- Frequency: 1850-1990 MHz - Gain: 4.8 dBi
- Frequency: 2110-2170 MHz - Gain: 1.0 dBi
- Impedance: 50 ohms
- Radiation: Omni
- Polarization: Vertical
- Ground Plane: Built-In Ground Plane
- Connector: FME Female
- Material: Whip - Stainless Steel
- Coax Cable: RG58 - 14 feet / 4.27 meters
- Height: 15 inches / 38.10 cm
- Mount: Glass Mounting with 3M™ Adhesive
|Frequency Range||See Description|
|Antenna Mount||Glass Mount|
|Connector Type||FME Female|