Wilson DataPro M2M Direct Connect Signal Booster

The Wilson Electronics DataPro™ Direct Connect is Wilson's first cellular signal booster developed specifically for Machine to Machine (M2M) installations. This cellular amplifier direct connect configuration is based on the same field tested, market-proven technology that powers Wilson’s Sleek in-vehicle cell phone signal booster for the consumer market.

Comes with:

• DataPro Signal Booster
• AC Power Supply
• 6ft RG-174 Cable with SMA Male connectors on each end.

Requires: External Antenna and antenna adapter to connect to your cellular data modem

The dual-band DataPro™ is ready to integrate with CDMA modem installations to provide strong, reliable cellular signal that ensures successful M2M data transfer. The Wilson DataPro™ works on all North American CDMA networks. The DataPro’s compact form factor and low price make it an ideal component for M2M installations in weak signal environments.

Integrators and OEMs can pair the DataPro™ with a variety of expertly designed Wilson Electronics cellular antennas for maximum system gain to overcome a weak signal. Weak signals can be caused many things, but the two main reasons are distance to the cell site, or obstructions such as brick, steel, trees or hills. The DataPro™ also incorporates power control logic that ensures maximum output power is within cellular network standards and will not interfere with a cellular network.

Wilson DataPro Installation Guide

Specifications

Connectors: SMA Female
Impedance: (input/output): 50 ohms
Dimensions: 3.3 x 1.9 x .8 inch (8.4 x 4.8 x 2.0 cm)
Frequency: 824-894 MHz / 1850-1990 MHz
Gain: 12dB Nominal
Power output (uplink)
   28.9 dBm 800 MHz  CDMA
   31.8 dBm 1900 MHz CDMA

Noise Figure: (typical) 3 dB nominal
Isolation: >40 dB
Power Requirements: 5V DC, 1A

Includes 6ft RG-174 cable with SMA Male connectors for connecting to data device.