Wilson Mobile Wireless 800MHz 3 Watt Amplifier *DISC

Wilson 800MHz In Vehicle Cellular Amplifier / Repeater

For Cars, Trucks and RV's

The Wilson bi-directional cellular repeater greatly improves signal strength inside a vehicle when using your 800MHz range cell phone. It does this without physical connection to your phone. It even allows multiple phones to be used simultaneously.

Comes With:

• 800MHz Wilson Wireless Mobile Amplifier
• Low Profile Antenna
• 6 Volt DC Power Supply (Cigarette Lighter Plug)

*Requires Outside Antenna (Not Included).

Antenna Requirements

The Wilson In Vehicle Amplifier comes with a Wilson Low Profile antenna for inside your vehicle. Another antenna for outside the vehicle is required and not included. For external antenna use a magnetic mount, pole mount or hole mount antenna. Do not use a glass mount antenna. The Wilson Trucker Antenna, Wilson Dual Band magnetic mount are recommended for outside use.

How it works.

The signal is received by the outside antenna from the cell site. It is then amplified and repeated to your cell phone from the inside antenna. When the phone transmits, the signal is received by the inside antenna, amplified, then repeated to the cell site via the outside antenna.

• Increases signal strength on send and receive in AMPS 824-894 MHz frequency range
• Wireless operation. No physical connection to your phone is required.
• Allows multiple phones to be use simultaneously.
• Works on AMPS frequency 824 - 894MHz (Analog and Digital) CDMA, TDMA and GSM. (Amplifies 824-894 range, 1900MHz is unaffected)
• Your phone will use less battery power for longer battery life.

TECH TIP: Coverage area from the inside antenna is limited by signal strength received by the outside antenna. If your cellular signal is very weak (2 bars or less) outside your vehicle or building, place your cell phone or pc card directly on the inside antenna for the most power. We would recommend using your Bluetooth headset for freedom of movement in these situations.

Cellular Amplifier Specifications

• Frequency: 824-849 MHz Uplink 869-894 MHz Down
• Gain (up/down): 40 dB / 40 dB
• Linear Power Output: +30 dBm
• Max Output Power: 3 Watts (Cell Site Controlled)
• Max RF Up/Down: +35 dBm / +10 dBm
• Noise Figure Typical: 4 db nominal
• Isolation: Uplink/Downlink more than 90 dB
• Power Requirements: 12 V, .5-1.5 (subject to Uplink power)
• Connectors: FME-Male 50 Ohms
• Dimensions: 5.5 x 4.3 x 1.4 (inch) or 14.0 x 10.8 x 3.5 (cm) Weight: 1.32 lbs or 0.6 kg

Installation Instructions